To your diameter for the most comfortable fit when slipping a bracelet on we recommend adding an additional ½ ˚1 inch if a bracelet has a larger design for a more comfortable fit! As a general rule, always make your beaded bracelet patterns longer at the beginning. Leave the ruler within the floor from the paper until finally you are ready to remove it.
You will need a pdf reader to view the file. Please feel free to distribute to whoever for free. Mark from the initial mark, and repeat the procedure inside the other 4 marks.
If You Are Using A Plain Strip Of Paper, Mark Your Size With A Pen Or Pencil Then Use A Ruler To Measure The Length.
This can be a very simple concept and will assist you to preserve time once you need. Always keep in mind how you plan to connect your bracelet and how much extra space this might take. Go away the ruler on the floor of the paper till you’re able to get rid of it.
Open The Printable File Above By Clicking The Image Or The Link Below The Image.
The template makes a cone with a radius of about 7.5 inches. To check the accuracy of your printout, position a credit card under the line below. To find the bracelet size, increase the wrist measurement by the increment below, based on how the customer wants the bracelet to fit.
It's Pretty Accurate I'd Say.
The template is in inches and ranges from 4 to 10. If using a plain strip of paper, mark your strip with a pen where the end of the bracelet needs to be. Then measure the paper strip with a ruler.
